Unit of Measure

Specifications

Available

Manufacturer Stock

Brands

 APEM

Manufacturer

 APEM

Series

 Q6

Mounting Hole Diameter

 6 mm

Bezel Style

 Prominent

Terminals

 Solder Lug/Fastons (2.0 x 0.5)

Bezel Finish

 Bright Chrome

Type of Illumination

 Bi-Color

Note for Type of Illumination

 Bi-color - The color is changed by reversing the polarity of the supply voltage.

Light Emitting Diode (LED) Color

 Green Red

Direct Current (DC) Voltage

 No resistor

Sealing

 Ingress Protection (IP67)

Operating Direct Current (DC) Voltage

 1.8 to 3.3 V

Maximum Operating Direct Current (DC)

 20 mA

Note for Operating Direct Current (DC)

 Customer to supply resistor for desired operating current.

Electrical Specifications

Red Color Prominent Intensity

 20 mcd

Green Color Prominent Intensity

 10 mcd

Red Color Flush Intensity

 15 mcd

Green Color Flush Intensity

 8 mcd

Red Color Forward Voltage

 2 V

Green Color Forward Voltage

 2.2 V

Environmental Specifications

Operating Temperature Range (Rear Plastic Body)

 -30 to 65 ºC-22 to 149 ºF

Operating Temperature Range (Rear Epoxy Body)

 -40 to 85 ºC-40 to 185 ºF

General Specifications

Maximum Reverse Voltage (VR)

 5 V
Viewing Angle1 30 to 100 º

Torque

 4 cNm

Maximum Panel Thickness

 7 mm

Materials

Material

 Plated brass bezel finished in bright chrome, black or satin gray and molded polycarbonate rear body

Features

Features
  • 3 mm colored diffused epoxy lens or 3 mm water clear super bright LEDs
  • Prominent, recessed and flush bezel styles
  • (2.0 x 0.5) solder lug terminals, pins or (200 mm long) wire terminations, other lengths available on request

Note

Note

 The company reserves the right to change specifications without notice.

All LED characteristics are dependent upon environmental conditions. Therefore published data should be considered nominal and subject to variations.
  • The operating voltage must not be exceeded by more than 10% as this will result in reduced life expectancy.
  • Luminous intensity is measured at 20 mA on a discrete led unless otherwise stated.
  • Luminous intensities and color shades of white LEDs may vary within a batch.
  • Luminous intensity will be reduced with lower operating current.
  • 1 Dependent on model